Flued boiler

An early proponent of the cylindrical form, was the American engineer, Oliver Evans who rightly recognised that the cylindrical form was the best from the point of view of mechanical resistance and towards the end of the 18th Century began to incorporate it into his projects. Probably inspired by the writings on Leupold’s “high-pressure” engine scheme that appeared in encyclopaedic works from 1725, Evans favoured “strong steam” i.e. non condensing engines in which the steam pressure alone drove the piston and was then exhausted to atmosphere. The advantage of strong steam as he saw it was that more work could be done by smaller volumes of steam; this enabled all the components to be reduced in size and engines could be adapted to transport and small installations. To this end he developed a long cylindrical wrought iron horizontal boiler into which was incorporated a single fire tube, at one end of which was placed the fire grate. The gas flow was then reversed into a passage or flue beneath the boiler barrel, then divided to return through side flues to join again at the chimney (Columbian engine boiler). Evans incorporated his cylindrical boiler into several engines, both stationary and mobile. Due to space and weight considerations the latter were one-pass exhausting directly from fire tube to chimney. Another proponent of “strong steam” at that time was the Cornishman, Richard Trevithick. His boilers worked at 40–50 psi (276–345 kPa) and were at first of hemispherical then cylindrical form. From 1804 onwards Trevithick produced a small two-pass or return flue boiler for semi-portable and locomotive engines. The Cornish boiler developed around 1812 by Richard Trevithick was both stronger and more efficient than the simple boilers which preceded it. It consisted of a cylindrical water tank around 27 feet (8.2 m) long and 7 feet (2.1 m) in diameter, and had a coal fire grate placed at one end of a single cylindrical tube about three feet wide which passed longitudinally inside the tank. The fire was tended from one end and the hot gases from it travelled along the tube and out of the other end, to be circulated back along flues running along the outside then a third time beneath the boiler barrel before being expelled into a chimney. This was later improved upon by another 3-pass boiler, the Lancashire boiler which had a pair of furnaces in separate tubes side-by-side. This was an important improvement since each furnace could be stoked at different times, allowing one to be cleaned while the other was operating.